Selection Of A Parameter; Enter-Parameter - KEB COMBIVERT F5 MULTI Applications Manual

Operation
4.1.2 Selection of a
Parameter
4.1.3 Adjustment of
Parameter Values
4.1.4

ENTER-Parameter

Chapter Section Page
4 1 4
The blinking point indicates the changeable area. By pressing the ENTER-key the
blinking point is shifted.
STOP
START
Select
parameter number
for non-programmable parameters (see 4.1.5)!
Changes between parameter value
Standard-Parameters
STOP
START
STOP
START
Parameter values can be changed only, when the parameter set
is not adjusted to „Active parameter set" (A) ! (see 4.1.6)
For some parameters it is not sensible that the selected values become active
immediately. For that reason they are called ENTER-parameters, they do not become
active until the ENTER-key is pressed.
Example: At digital setting of rotation direction the rotation reverse (r) shall be selected
from standstill (LS). As shown above, the actuation must be done via rotation
forward (F). However, the drive must not start yet, first the rotation direction
reverse has to be selected and confirmed with ENTER (point disappears).
Date Name: Basis
KEB COMBIVERT F5
04.05.04
ENTER
F/R
START
Select
parameter group
A parameter set number is not displayed
FUNCT
SPEED
Changing of
- Values are
immediately
accepted and
stored non-
START
volatile!
START
Fundamentals
ENTER
F/R
STOP
START
Select
parameter set
and parameter designation
ENTER-Parameters
- During changing a point is
indicated behind the last
digit
STOP
- The value is accepted with
ENTER and stored non-
volatile (point disappears)
STOP
ENTER
F/R
© KEB Antriebstechnik, 2002
All Rights reserved
STOP