KEB COMBIVERT F5 MULTI Applications Manual page 104

Functional Desription
ru.33 ANOUT1 pre ampl. display
Adr.
0221h
This parameter shows the value of the analog signal ANOUT1 in percent before passing the characteristic amplifier
(also see Chapt. 6.2. ÑAnalog outputsì).
ru.34 ANOUT1 post ampl. display
Adr.
0222h
This parameter shows the value of the signal given out on analog output ANOUT1 (terminal X2A.5) in percent. A value
of 0...±115 % correponds to an output signal of 0...±11,5 V (also see Chapt. 6.2 ÑAnalog outputsì).
ru.35 ANOUT2 pre ampl. display
Adr.
0223h
This parameter shows the value of the analog signal ANOUT1 in percent before passing the characteristic amplifier
(also see Chapt. 6.2. ÑAnalog outputsì).
ru.36 ANOUT2 post ampl. display
Adr.
0224h
This parameter shows the value of the signal given out on analog output ANOUT2 (terminal X2A.6) in percent. A value
of 0...±115 % correponds to an output signal of 0...±11,5 V (also see Chapt. 6.2 ÑAnalog outputsì).
ru.37 Motorpoti actual value
Adr.
2025h
The motorpoti-function in the KEB COMBIVERT imitates a mechanical, motor operated potentiometer. The control
occurs via 2 programmable inputs (Ñpoti upì and Ñpoti downì). The display is limited by oP.53/54. The adjustment of the
motorpoti is done with the parameters oP.50...oP.59 (also see Chapt. 6.9.3 ÑMotorpotiì). By way of the bus the motorpoti
can be set to any chosen value between -100...100%. In addition to the inputs the motorpoti can be operated with the
keys ÑUPì and ÑDOWNì. Then the rate of change is not constant.
Chapter Section Page
6 1 14
min max
-400 400
min max
-115 115
min max
-400 400
min max
-115 115
min max
-100 100
Date Name: Basis
KEB COMBIVERT F5-M / S
12.05.04
Operating and Unit Data
%
0,1
%
0,1
%
0,1
%
0,1
%
0,01
© KEB Antriebstechnik, 2002
All Rights reserved
default
-
default
-
default
-
default
-
default
-