KEB COMBIVERT F5 MULTI Applications Manual page 102

Functional Desription
ru.25 Output terminal state
Adr.
0218h
Display of the currently set external and internal digital outputs. According to following table a certain decimal value is
given out for each digital output. If several inputs are set then the sum of their decimal values is displayed.
Bit -No.
ru.26 Active parameter set
Adr.
021Ah
The KEB COMBIVERT can fall back on 8 internal parameter sets (0-7). Through corresponding programming the inverter
can independently change parameter sets and is thus able to drive different operating modes. This parameter shows the
parameter set, with which the inverter is currently running. Independent of it another parameter set can be edited by bus
(also see chapter 6.8).
ru.27 AN1 pre amplifier display
Adr.
021Bh
This parameter indicates the value of the analog signal AN1 in percent on the differential voltage input (terminal X2A.1 /
X2A.2) before signal amplification. In dependence on an.10 the indicated value 0...±100 % corresponds to: 0...±10 V;
0...±20 mA or 4...±20 mA (also see Chapt. 6.2 ÑAnalog inputsì).
ru.28 AN1 post amplifier display
Adr.
021Ch
This parameter shows the value of the analog signal AN1 in percent after passing the characteristic amplifier. The range
of indication is limited to ±400 % (also see Chapt. 6.2 ÑAnalog inputsì).
Chapter Section Page
6 1 12
min max
0 255
Decimal value
0 1
1 2
2 4
3 8
4 16
5 32
6 64
7 128
min max
0 7
min max
-100 100
min max
-400 400
Date Name: Basis
KEB COMBIVERT F5-M / S
12.05.04
Operating and Unit Data
-
1
Output
Out 1 (transistor output 1)
Out 2 (transistor output 2)
Out 3 (relais FLA,FLB,FLC)
Out 4 (relais RLA,RLB,RLC)
Out A (internal output A)
Out B (internal output B)
Out C (internal output C)
Out D (internal output D)
1
%
0,1
%
0,1
default
-
Terminal
X2A.18
X2A.19
X2A.24...26
X2A.27...29
none
none
none
none
default
-
-
default
-
default
-
© KEB Antriebstechnik, 2002
All Rights reserved