KEB COMBIVERT F5 MULTI Applications Manual page 297

Positioning and Synchronous Control
The summing-up of the basic
Posi/Synch input select (PS.2)
© KEB Antriebstechnik, 2002
All Rights reserved
The position of S! and S2 in the graphic below, is dependent on the parameters
setting cS.1, PS.1, PS.0, ec.39.
Basically applies:
-speed-controlled open, but feedback always with gear factor = 1
-Posi S1,S2 open
-Posi over output S2 closed, gear factor for the speed precontrol
-Synchronous Mode S2 closed
-ec.39 =1 , S1 closed, gear factor enters into the speed detection
Position detection
If the Posi Mode is selected with PS.0, the posi-module can be activated by setting
the input defined with PS.2.
Bit -No. Decimal value Input
0
1
2
3
4
5
6
7
8
9
10 1024
11 2048
Name: Basis
KEB COMBIVERT F5-M / S
Functional Desription
S1
Gear factor
ec.29 ec.4
ec.31
ec.5
S2
Gear factor
ec.30 ec.14
ec.32
ec.15
1 ST (prog. input Ñcontrol release / resetì)
2 RST (prog. input Ñresetì)
4 F (prog. input Ñforwardì)
8 R (prog. input Ñreverseì)
16 I1 (prog. input 1)
32 I2 (prog. input 2)
64 I3 (prog. input 3)
128 I4 (prog. input 4)
256 IA (internal input A)
512 IB (internal input B)
IC (internal input C)
ID (internal input D)
Evaluation
ec.33
-
ec.34
-
Terminal
X2A.16
X2A.17
X2A.14
X2A.15
X2A.10
X2A.11
X2A.12
X2A.13
Date Chapter Section
6 11
06.05.04
6
ru.54
none
none
none
none
Page
15