KEB COMBIVERT F5 MULTI Applications Manual page 101

Operating and Unit Data
ru.23 Output condition state
Adr.
0217h
With parameters do.0Ödo.7 switching conditions can be selected which serve as basis for the setting of the outputs.
This parameter indicates which of the selected switching conditions are met, before they are linked by the programmable
logic or inverted (see Chapter 6.3 ÑDigital Outputs). According to following table a certain decimal value is given out for
the parameters do.0Ödo.7. If several of the switching conditions selected with these parameters are met, then the sum
of the decimal values is displayed.
Bit -No.
ru.24 State of output flags
Adr.
0217h
Display of the links after logic step 1. The selected switching conditions are linked in logic step 1 (do.8...24) and
indicated here (see Chapt. 6.3 ÑDigital outputsì). According to following table a specific decimal value is given out for
each linkage. If several links are set, the sum of the decimal values is indicated.
Bit -No.
© KEB Antriebstechnik, 2002
All Rights reserved
min max
0 255
Decimal value
0 1
1 2
2 4
3 8
4 16
5 32
6 64
7 128
min max
0 255
Decimal value
0 1
1 2
2 4
3 8
4 16
5 32
6 64
7 128
Name: Basis
KEB COMBIVERT F5-M / S
Functional Desription
-
1
Output
switching condition 0 (do.0)
switching condition 1 (do.1)
switching condition 2 (do.2)
switching condition 3 (do.3)
switching condition 4 (do.4)
switching condition 5 (do.5)
switching condition 6 (do.6)
switching condition 7 (do.7)
-
1
Output
flag 0
flag 1
flag 2
flag 3
flag 4
flag 5
flag 6
flag 7
12.05.04
default
-
default
-
Date Chapter Section
6 1
6
Page
11