Cp-Parameter Definition; Survey - KEB COMBIVERT F5 MULTI Applications Manual

CP-Parameter Definition

6.13 CP-Parameter
Definition

6.13.1 Survey

© KEB Antriebstechnik, 2002
All rights reserved
Once the development stage of a machine is completed, usually only a few parameters
are required for the adjustment or the control of the inverter. To make the handling
easier and the user documentation more understandable as well as to increase the
safety of operation against unauthorized access, the possibility exists to create the
own user surface with the CP-parameters. For that purpose 37 parameters (CP .0...CP.36)
are available, 36 of them (CP.1...CP.36) are free for assignments.
Fig. 6.12.1 Definition structure
440
Application Mode
ud.15
Address
ud.16
1
Set/Norm
ud.17
Address
ud.16
2
Set/Norm
ud.17
Adress
ud.16
36
Set/Norm
ud.17
With ud.15 the CP-parameter that is to be edited is determined. With ud.16 and ud.17
the CP-parameter is defined through its address and the respective set. Depending on
the adjusted password (CP.0 or ud.1)
- the adjusted parameter is directly displayed in the Service Mode
- the adjusted parameter is displayed as CP-parameter in the CP-Mode
Parameter CP.0 is not programmable and always contains the password input. If the
inverter is in the Application Mode or Service Mode ud.1 is used for the password
input.
The parameters ud.15...17 as well as Fr.1 are not permitted as CP-parameter and are
acknowledged as invalid parameter address. When entering an invalid parameter
address the parameter is set to „oFF" (-1). The appropriate CP-parameter is not
displayed at this setting.
Name: Basis
KEB COMBIVERT F5
Functional Description
Password
CP.0 / ud.1
330
Read/
Service Mode
Write
ru.3
ru. 1
An.4
Date
04.05.04
200 100 500
Read
Drive Mode
only
CP-Mode
CP.1
CP.2
CP.36
Chapter Section Page
6 13 3
6