KEB COMBIVERT F5 MULTI Applications Manual page 175

Setpoint- and Ramp Adjustment
Ramp mode (oP.27)
© KEB Antriebstechnik, 2002
All Rights reserved
Fig. 6.4.9.b Forward deceleration with constant ramp time
n _ s o l l f_soll
n _ i s t
f_ist
t_rampe
The different ramp functions can be adjusted separately for every frequency change
(acceleration forward, deceleration forward and so on). The selection is made with
oP.27 and is adjustable separately in each set.The function is activated after
pressing ÑENTERì. In case of several selections the sum of the values must be
entered:
Ramp Bit-No Value
0
Acc. 0 + 1 1
forward 2
3
0
Dec. 2 + 3 4
Vorward 8
12
0
Acc. 4 + 5 16
Reverse 32
48
0
Dec. 6 + 7 64
Reverse 128
192
* Do not adjust these values - they are only sensible, if acceleration respectively
deceleration do not occur from/to standstill.
If the mode constant time is activated for a ramp, then the s-curve function is
deactivated for this ramp. The ascent is limited to minimum 1000 rpm (dep. on
ud.2) / 4800 s.
Name: Basis
KEB COMBIVERT F5-M / S
Functional Desription
t_rampe t_rampe
Mode Reference speed
const. ascent 1000 rpm (dep. on ud.2)
const. time actual set value
* const. time last set value at constant run
reserved
const. ascent 1000 rpm (dep. on ud.2)
* const. time actual set value
const. time last set value at constant run
reserved
const. ascent 1000 rpm (dep. on ud.2)
const. time actual set value
* const. time last set value at constant run
reserved
const. ascent 1000 rpm (dep. on ud.2)
* const. time actual set value
const. time last set value at constant run
reserved
Date
12.05.04
t_rampe
t_rampe
t
Chapter Section Page
6 4 17
6