Connection To The Cooling System - KEB COMBIVERT F5 MULTI Applications Manual

8.1.3 Connection to the
Cooling System
closed cooling circuit
© KEB Antriebstechnik, 2002
All rights reserved
The connection to the coolant must be done with flexible pressure-proof tubes and
it must be secured with clips. (note flow direction and check tightness!) The
connection to the cooling system is done via 1/2 inch secrewed glands . (Whitworth-
pipe thread of DIN ISO 228-1).
The connection to the cooling system can occur as closed or opened cooling
circuit. It is dependent on the local circumstances and it is preset by the mechanical
engineer.
In case of a closed cooling circuit the outflow coolant is cooled down by a heat
exchanger or by a re-cooling system and refeed back into the cooling cicuit.
Valve
Pump
Heat exchanger,
Re-cooling
Inflow Outflow
Name: Basis
KEB COMBIVERT F5
Special Operation
do.xx
COMBIVERT
system
Coolant
KEB
Date Chapter Section
1
8
10.04.02
Page
5