Control Cabinet Installation; Mounting Instructions; Table 21: Mounting Instructions For Built-In Version; Table 22: Mounting Instructions For Push-Through Version - KEB COMBIVERT F6 Series Instructions For Use Manual

CONTROL CAbINET INSTALLATION

4.2 Control cabinet installation

4.2.1 Mounting instructions

For the mounting of the drive controllers the following mounting materials with the appro-
priate quality were tested by KEB.
Required material
Socket screw ISO 4762 - M6 - 8.8
Flat washer ISO 7092 - 6 - 200 HV
Table 21:
Required material
Socket screw ISO 4762 - M5 - 8.8
Flat washer ISO 7092 - 5 - 200 HV
Table 22:
NOTICE
46
Mounting instructions for built-in version
Mounting instructions for push-through version
Use of other fixing material
► The alternatively selected fixing material must meet the above ma-
terial characteristics (quality) and tightening torques !
The use of other fixing materials is beyond the control of KEB and is
therefore the sole responsibility of the customer.
Tightening torque
6,5 Nm
58 lb inch
―
Tightening torque
2,5 Nm
22 lb inch
―