Profibus-Dp-Operator 00.F5.060-3000 - KEB COMBIVERT F5 MULTI Applications Manual

Networks
11.1.5 Profibus-DP-
Operator
00.F5.060-3000
Fig. 11.1.5 Profibus-DP Operator
PAR
PDOUT
PDIN
Diag
© KEB Antriebstechnik, 2002
All rights reserved
The PROFIBUS-DP-interface module realizes a passive user (Slave). This means
that the PROFIBUS-DP-interface module only transmits, if it receives an enquiry for
that from the master.
The PROFIBUS-DP-protocol defines different operating conditions, that must be
executed first, before the actual user data can be exchanged. The responsible DP-
master must first parameterize and then configure his slaves. If these two functions
are successfully completed, the cyclic exchange of user data begins.
START
ENTER FUNC.
F/R SPEED
STOP
ANTRIEBSTECHNIK
ANTRIEBSTECHNIK
PBS1 PBS2
Name: Basis
KEB COMBIVERT F5
Network Hardware
PAR (green): Parameterizing chanel
active
PDOUT (green): PDOUT-data are written to
the FI control.
PDIN (green): PDIN-data are read by the
FI control.
E (red): on ==> Inverter ready for
E
operation
blinking ==> Inverter failure
off ==> No supply voltage
Diag: Diagnostic interface to the
PC
PBS1: PROFIBUS-DP-interface
(socket-connector)
PBS2: PROFIBUS-DP-interface
(pin-connector)
Date
04.05.04
Chapter Section Page
11 1 5
11