Agilent Technologies 93000 SOC Series Training Manual page 99

5-4 Fixture Delay
Agilent 93000 SOC Series User Training Part 1, October 2004
– Enter a file name in this dialog box.
The system stores this file in the ch_attributes directory
residing in your device directory.
This file is load board specific. If you test your device on different load
board you can create a corresponding file for every load board.
Later on you simply load the file of the load board you use for your test
(select File -
Device Specific Calibration File Structure
The fixture delay and pin attributes are stored in the following file
structure:
<device directory>
ch_attributes/
Figure 53 Device Specific Calibration File Structure
ch_attributes/
ACTCatr
pin_attributes/
Load).
calibration/
ACTCatr
Fixture delays of each channel are stored in this
directory
Contains the name of the current active channel
attributes file (located in ch_attributes)
Stores the pin_attributes data used for system
"tweaking".
pin_attributes/
Calibration
99