Agilent Technologies 93000 SOC Series Training Manual page 319

11-2 Standard Test Function Groups
hp-ux_escape
get_utility_lines
set_utility_lines
Agilent 93000 SOC Series User Training Part 1, October 2004
Sweep Tests
Descriptions of the tests in the Sweep Tests group are listed below. For
detailed information, refer to the Standard Test Function Reference.
shmoo_2d • shmoo_2d — performs a two dimensional shmoo plot.
• shmoo_spec — performs a two dimensional shmoo plot of the spec
parameters specified. Any other resources that are related to these
spec parameters in the equation system are tracked with the spec
parameters. This test function requires an equation-based test
setup.
Other Tests
Descriptions of some of the tests that might be found in the Other Tests
group are listed below. (The tests in this group are system-specific.) For
detailed information, refer to the Standard Test Function Reference.
fw_escape • fw_escape
lets you execute a firmware command.
• hp-ux_escape
lets you execute an UX shell command.
comment • comment
adds a comment line to the results output.
• get_utility_lines
reads the state of the utility line inputs.
header • header
defines a header to be used for test results.
• set_utility_lines
sets the utility line outputs.
Standard Test Functions
319