Agilent Technologies 93000 SOC Series Training Manual page 328

User training part 1

Hide thumbs Also See for 93000 SOC Series:

Table of Contents

Standard Test Functions

7 Select whether you want to make the measurement testing only a

single polarity, or whether you also want to repeat the test with the

opposite polarity. The second test takes place only if the first test

8 Type your result text in the output entry field. The label $P means

that the result string contains an entry for each pin in the pinlist.

Continuity Test Using Programmable Load

This test is used to:

• check the chip bonding and connections to the test fixture,

• check protection circuits in the DUT such as input clamp diodes by

forcing a current into a device pin and measuring the voltage

between that pin and ground,

• check for short-circuits to ground and from pin to pin.

DRIVE 0.00 Volts

Continuity Test Using the Programmable Load

Prior to execution of the test, the status of the tester is checked to

determine if it is currently connected or disconnected. If it is

connected, then the DISCONNECT test function is executed. If it is

Agilent 93000 SOC Series User Training Part 1, October 2004

to perform the test or

PROGRAMMABLE

11-4 The Continuity Test Function

to abort it once it has

Show Quick Links

Table of Contents