Agilent Technologies 93000 SOC Series Training Manual page 264

Vector and Pattern Management
Open Select Test window
Select wavetable
264
Changing the Wavetable in the Vector Setup
The wavetable you use in the vector setup only determines the repre-
sentation of the vector memory in the Vector Setup Editor. So changing
the wavetable does not have any impact on the content of the vector
memory.
You change the wavetable as follows.
1 In the Vector Setup Editor, select
You see the Select Test window.
2 In the Select Test window, click in the Wave Table edit field, and
select a wavetable from the dropdown menu (see
3 Click Select.
Figure 168 Changing the Wavetable
Multi Mode
You see in
as a Default Display mode in wavetables which define different device
cycles for different pins. In multi mode every pin (or pin group) is asso-
ciated with a DevCyc column in the Vector Setup Editor.
Physical Waveforms should be displayed with the Multi Mode. The
other Display Modes are useful with Logical Waveforms and will be
explained in "Logical Waveforms" on page 307.
Agilent 93000 SOC Series User Training Part 1, October 2004
Figure 168 the field Display Mode. The multi mode is used
10-2 Vector Verification
Select - Select a Label.
Figure 168).