Agilent Technologies 93000 SOC Series Training Manual page 192

Timing Setup
192
that edge has the same edge delay (not defined in the Physical Wave-
form Table) in all waveforms where it is used. However, the actions
occurring at that edge can change from waveform to waveform.
• The Physical Waveform Table can store up to 32 physical waveforms
and one break waveform. That is, the physical waveform indices
cover the range 00 - 1f (hex representation of physical waveform
indices).
Wavetables
Physical waveforms are defined in wavetables.
Figure 114
Figure 114 Wavetable Setup syntax
The following key words set up a wavetable:
WAVETABL
• You start the wavetable definition with the key word WAVETBL
followed by a description (name).
DISPLAY • The key word DISPLAY specifies the default display mode for
patterns using this wavetable for the vector setup later on. You
usually choose "multi".
Agilent 93000 SOC Series User Training Part 1, October 2004
explains the used syntax to set up a wavetable:.
9-3 Wavetable Setup