Agilent Technologies 93000 SOC Series Training Manual page 123

7-3 Entering the Pin Configuration
Open Pin Configuration window
Agilent 93000 SOC Series User Training Part 1, October 2004
7-3 Entering the Pin Configuration
To enter the Pin Configuration you have to open the Pin Configuration
editor:
1 Either,
– double-click the Config icon in the Data Manager setup page.
Or
– single-click the
page.
N O T E Much of the information for the pin configuration can be imported
from CAE data using translation tools, but the assignment to the tester
channels must be done here.
2 In the Pin Configuration editor, select
editor mode.
Figure 68 Pin Configuration Editor – Editor Mode
3 Enter the Pin Number if required.
You can generate the numbers automatically by using
numbers.
pin config button in the Main toolbar config
Mode - editor
Defining the Pins
to enter the
Edit - create
123