Agilent Technologies 93000 SOC Series Training Manual page 266

Vector and Pattern Management
266
Representation of Vector Labels
Using Device Cycle Names of the Default Mapping
In the timing setup you have defined the wavetable gross_func_wtb for
the 74ACT299 device. You can now use this wavetable as the wavetable
in the vector setup to display the default mapping.
In other words, this wavetable contains no Device Cycle Names, so you
see the physical waveform indices displayed in the Vector Setup Editor.
Figure 170
Figure 170 Vector Setup Using Default Device Cycle Names
Using User Defined Device Cycle Names
In the timing setup you have also defined the wavetable
gross_func_devcyc_wtb for the 74ACT299 device. Here, the physical
waveforms are identified by user defined device cycle names. So the
vector setup will display these device cycle names.
Figure 171
to the previous vector setup is an alternative representation of the
content of the vector memory in which user defined device cycle names
are used in the Vector Setup Editor.
Agilent 93000 SOC Series User Training Part 1, October 2004
shows this vector setup.
shows the same vector setup as above. The only difference
10-2 Vector Verification