Agilent Technologies 93000 SOC Series Training Manual page 223

9-8 Logical Waveforms
waveforms in spec_search_wtb
Example wavetable with waveforms
Agilent 93000 SOC Series User Training Part 1, October 2004
Figure 139 Syntax of a wavetable using Logical Waveforms
The wavetable spec_search_wtb defines:
• Logical waveforms using the command WFDS and the associated
data parameters. A logical waveform can contain a maximum of two
drive and two receive data parameters.
• Logical waveform indices following the WFDS command.
• The physical waveforms resulting from a logical waveform.
The physical waveforms associated with a logical waveform are
derived from the logical waveform by replacing the data parameters
of the logical waveform by specific actions.
• Device cycles using the command DCDF. The command DCDF is
followed by a user defined device cycle name and - in our case - by
one logical waveform index number. That is, the device cycle name
is assigned associated with one of the logical waveforms defined for
the pin "mode".
The following complete wavetable defines the logical waveforms and
the associated physical waveforms as follows:
WAVETBL spec_search_wtb
# Inputs are implemented with SBC waveforms to allow
# testing of setup and hold time for input signals
Timing Setup
223