Agilent Technologies 93000 SOC Series Training Manual page 525

18-7 Executing Firmware Commands
Agilent 93000 SOC Series User Training Part 1, October 2004
7 Use the radio buttons to set the tester state.
You may leave the tester state unchanged, or set it to connected or
disconnected prior to test execution.
Execute 8 Click the
The tester state is set as defined and the FW-setup-command is
executed. Then the FW-execution-commands will be executed and
repeated, according to the set repeat mode.
Though the results of such a test returned to the test flow are at most
the pass/fail results from any commands embedded in the FW-execu-
tion-command string, no values can be returned.
N O T E To have even more possibilities, low level programming in C or VEE is
required.
exec button.
Advanced Testflow Control
525