Agilent Technologies 93000 SOC Series Training Manual page 279

10-5 Editing Vectors Vector and Pattern Management
10-5 Editing Vectors
Searching for a Pin/Pin Group
The Vector Setup allows you to search for a pin or a pin group which
has been specified in the currently used display format.
To perform a search, you enter the pin or pin group name into the entry
field in the upper left corner of the Vector Setup window.
You can directly type in the pin or pin group name into the entry field.
Alternatively, you can select the pin or pin group from a selection box.
You do this as follows:
1 Double click on the Pin/Group Name entry field.
You see the selection box Select Pin /Group Name.
2 Highlight a pin or pin group in the Pins/Groups list and click Select.
Figure 180 Selecting a Pin for a Search
Appending a Vector
To append a vector at the end of a label click into an arbitrary device
cycle column of the line following the last vector, and enter a device
cycle name.
279
Agilent 93000 SOC Series User Training Part 1, October 2004