Agilent Technologies 93000 SOC Series Training Manual page 189

9-3 Wavetable Setup
Agilent 93000 SOC Series User Training Part 1, October 2004
Figure 110 Waveform example (receive edge)
Waveforms are determined by a sequence of drive and/or receive
actions. An action defines a drive or receive signal. It occurs at a
certain point in time. This point in time is called an edge.
A sequence of edges together with the associated actions defines a
waveform. Depending on the actions which can occur at an edge, we
have drive edges and receive edges.
Compare (Receive) Actions
There are two types of compare actions:
Edge compare
You compare the device output to a certain voltage level or voltage
level range at the point in time defined by the edge position.
Table 111 lists the strobe compare actions.
Timing Setup
189