Agilent Technologies 93000 SOC Series Training Manual page 239

9-9 Fixed Timing
Defining a Device Cycle
Placing the Edges
Agilent 93000 SOC Series User Training Part 1, October 2004
Figure 155
the device cycle edit area of the Timing Setup window, as you proceed
through the steps to create the Timing setup.
Figure 155 Steps to Create the Timing Setup
A "*" at the end of the device cycle name shows that this device cycle
has not been defined so far.
Starting with the first line in
perform:
1 Define a Device Cycle
2 Place the Edges
3 Create the Waveforms
The first step when setting up the timing is to define a device cycle. The
device cycle will be defined for one or more pins. The device cycle name
can describe the actions which take place at one or more pins.
1 Select DevCycEdit -
2 Click the
3 Enter a name for the Device Cycle (for example, cycle).
4 Enter the length of the Device Cycle: 1.
5 Click the
The name appears in the DevCyc column for all pins.
The second step when setting up the timing is to place the edges in the
tester cycles for each pin or pin group:
6 Click into the
7 Click into the upper portion of the entry in the
the number of the edge to be placed.
8 Click into the lower portion of the entry in the
the selected edge beside the
9 Either
shows the change in appearance of the data for one pin in
Figure
Define.
select all button to select all pins.
Define button.
/ column to select the pin or pin group.
I O
/
I O
155, there are three steps to
/ column to select
I O
/ column to place
I O
column.
Timing Setup
239