Agilent Technologies 93000 SOC Series Training Manual page 487

17-2 Pin Margin Setup
Agilent 93000 SOC Series User Training Part 1, October 2004
Figure 297 Timing Resource Options
Level Options
Select which level sets you want in your test.
If you want to specify individual sets rather than All or Primary, click
on Specified
Figure 298 Level Options
1 From the list of level sets, highlight the ones you want to use.
N O T E
Independent from your selection, only those level sets will be used that
are actually used in the vector pattern (either as primaries or by
changing sets using the sequencer command CLEV).
2 Select which levels you want to use.
Figure 299 Level Sets
Creating a Control File
The pin margin tool logs all operations of the user during the interac-
tive use. This log file can be saved as a control file to repeat exactly
these steps when you invoke the pin margin tool with the control file.
To create a control file proceed as follows:
and a list of level sets is displayed.
Measuring Pin Margins
487