Agilent Technologies 93000 SOC Series Training Manual page 451

16-4 The Standalone Shmoo Tool
Write Permissions in the Device
load primary sets
Agilent 93000 SOC Series User Training Part 1, October 2004
16-4 The Standalone Shmoo Tool
Prerequisites
Xdefaults Before you launch the Shmoo Tool you have to merge the Xdefaults of
the file /opt/hp93000/soc/pws/data/.Xdefaults. Execute the
command
xrdb -merge /opt/hp93000/soc/pws/data/.Xdefaults
You can customize your display colors and save shmoo setups and
Directory
results. This information is stored the directory shmoo residing in your
device directory. Make sure that you have write access to this direc-
tory.
You can now start the SmarTest and launch the Shmoo Tool.
A shmoo plot can be based on
• a functional test
• an arbitrary testfunction
The shmoo plot uses the setup defined by the primary sets. That is, you
have to load the primary sets to the hardware before you can make a
shmoo plot.
There are two options to download a setup:
• Execute a testflow and set on hold the testsuite which primaries you
want to use for the shmoo.
• Use the Data Manager to load your setup and define the primary
sets.
Shmoo Tool
451