Agilent Technologies 93000 SOC Series Training Manual page 263

10-2 Vector Verification
Open Select test window
Label definition
Agilent 93000 SOC Series User Training Part 1, October 2004
You define a label as follows.
1 Choose
N O T E If no vector data have been entered so far, the dialog box Select Test
is opened automatically when you open the Vector Setup Editor.
Figure 167 Select Test Dialog Box
2 Enter a label name in the entry field Test Label.
3 Mark the check box Wave Table.
4 Click into the entry field Wave Table.
You see a menu of the wavetables defined in timing setup.
5 Select a wavetable from this menu.
The wavetable determines the valid device cycle names and data
parameter values when you set up the vectors. Remember that
device cycle names and data parameters are defined in the waveta-
bles.
6 Click in the Display Mode entry mode, and select multi.
7 Click Select.
The dialog box Select Test closes. Now you can define the vectors for
the label specified in the dialog box Select Test.
Select - Select a Label
Vector and Pattern Management
in the Vector Setup Editor
263