Agilent Technologies 93000 SOC Series Training Manual page 284

Vector and Pattern Management
284
3 In the selection box containing the device pins select a pin.
The sequence of device cycles of this pin and the corresponding
data parameters are copied. For the device cycles of all other pins
the copy contains the default device cycle.
4 Under source, specify the vector range you want to copy.
You can copy All Vectors or a Vector Range.
If you choose Vector Range you must specify the first and the last
vector of the range in the associated entry fields. If you want this
range to be copied several times in sequence you can also specify a
repeat factor.
5 In start vector, specify the position in your vector flow where you
want to insert the copied vectors or the beginning of the vector
range you want to overwrite.
If you want to insert a vector range the copied vector range is
inserted before the start vector.
Note that you can also specify the first empty line of your vector
setup to append the copied vector range. If you want the copied
vectors to overwrite a vector range specify the first vector to be
overwritten as a Start Vector.
Figure 184 Copy and Paste of Vectors
Search and Replace
You can search and replace device cycle names or device cycle names
and associated data parameters (you cannot search for just a data
parameter).
In order to search and replace a vector proceed as follows:
Agilent 93000 SOC Series User Training Part 1, October 2004
10-5 Editing Vectors
Copied vector
range
Inserted vector
range from
start vector 10