R&S FSV-K7 Operating Manual page 95

®
R&S FSV-K7/K7S
Example:
Manual operation:
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:STAT <State>
This command turns a peak search on and off.
Suffix:
<n>
<m>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:MARKer<m>:FUNCtion:PNOise <State>
This command switches the phase noise measurement for the specified marker on or
off in the specified window. The phase noise power density is measured at the position
of the markers. The result can be queried with
FUNCtion:PNOise:RESult?
Suffix:
<n>
<m>
Parameters:
<State>
Example:
Mode:
CALCulate<n>:MARKer<m>:FUNCtion:ZOOM <Range>
This command defines the range to be zoomed around marker 1. Marker 1 is activated
first, if necessary.
The subsequent frequency sweep is stopped at the marker position and the frequency
of the signal is counted. This frequency becomes the new center frequency, and the
zoomed span is set.
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
CALC:MARK:FUNC:FPE:LIST:SIZE 10
The marker peak list will contain a maximum of 10 peaks.
See "Max Peak Count"
.
Selects the measurement window.
Selects the marker.
ON | OFF
*RST: OFF
CALC:MARK:FUNC:FPE:STAT ON
Activates marker peak search
See "Peak List On/Off"
on page 93.
.
1...4
window
1...16
marker
ON | OFF
*RST: OFF
CALC:MARK2:FUNC:PNO ON
Switches on the phase noise marker 2.
ADEMOD
on page 74
on page 74
CALCulate<n>:MARKer<m>:
95