R&S FSV-K7 Operating Manual page 117

®
R&S FSV-K7/K7S
PROBe:SETup:MODE <Mode>
This command defines which action is taken when the probe's micro button is pressed.
Parameters:
<Mode>
Example:
Manual operation:
PROBe:SETup:NAME?
This command returns the name of the connected probe.
Example:
Usage:
PROBe:SETup:STATe?
This command queries whether a probe is connected to the instrument's [RF Input] and
USB connectors and was recognized by the R&S FSVA/FSV.
Example:
Usage:
PROBe[:STATe] <State>
This command activates a connected probe. Use this command to switch off the probe
and measure the digital input without considering the transducer factor of the probe.
Parameters:
<State>
Example:
Manual operation:
2.3.6 SENSe Subsystem (Analog Demodulation, R&S FSV–K7)
The SENSe subsystem is organized in several subsystems. The commands of these
subsystems directly control device-specific settings, they do not refer to the signal
characteristics of the measurement signal.
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
RSINgle
A single sweep is performed.
NOACtion
No action is taken.
*RST: OFF
PROB:SET:STAT ON
See "Probe Config" on page 77
PROB:SET:NAME?
Query only
PROB:SET:STAT ON
Query only
ON | OFF
*RST: OFF
PROB:STAT ON
See "Probe Config" on page 77
117