R&S FSV-K7 Operating Manual page 77

Analog demodulation and fm stereo
Table of Contents

Advertisement

®
R&S
FSV-K7/K7S
Tracking Generator
This softkey is only available if the R&S FSV option Tracking Generator (R&S FSV-B9)
or External Tracking Generator (R&S FSV-B10) or both are installed. It is not available
in I/Q Analyzer mode.
For details see the base unit description.
Power Sensor
For precise power measurement a power sensor can be connected to the instrument
via the front panel (USB connector) or the rear panel (power sensor, option R&S FSV-
B5). The Power Sensor Support firmware option (R&S FSV-K9) provides the power
measurement functions for this test setup.
This softkey is only available if the Power Sensor option (R&S FSV-K9) is installed.
For details see the chapter "Instrument Functions Power Sensor (K9)" in the base unit
description.
This softkey is available for RF measurements.
Trigger Out
Sets the Trigger Out port in the Additional Interfaces (option R&S FSV-B5 only) to low
or high. Thus, you can trigger an additional device via the external trigger port, for
example.
Remote command:
OUTPut:TRIGger
External Mixer
Opens the submenu for the external mixer.
For details see the base unit description.
Probe Config
With firmware R&S FSVA/FSV 1.61SP2 or newer, active probes are supported (via an
adapter). This softkey opens an edit dialog box to activate and configure a connected
probe which is to provide an input signal. It is only available if a probe is connected to
the instrument's [RF Input] and USB connectors.
For details see the base unit Operating Manual.
Remote command:
PROBe[:STATe]
PROBe:SETup:MODE
Signal Source
Opens a dialog box to select the signal source.
For "Digital Baseband (I/Q)", the source can also be configured here.
Input Path ← Signal Source
Defines whether the "RF Radio Frequency" or the "Digital IQ" input path is used for
measurements. "Digital IQ" is only available if option R&S FSV-B17 (R&S Digital I/Q
Interface) is installed.
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
on page 184
on page 117
on page 117
Softkeys of the Analog Demodulation option
77

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fsv-k7s

Table of Contents