R&S FSV-K7 Operating Manual page 155

®
R&S FSV-K7/K7S
[SENSe:]FREQuency:CENTer:STEP:LINK:FACTor <Factor>
This command defines a step size factor if the center frequency step size is coupled to
the span or the resolution bandwidth.
Parameters:
<Factor>
Example:
Manual operation:
2.3.6.8 SENSe:SWEep Subsystem (Analog Demodulation, R&S FSV–K7)
The SENSe:SWEep subsystem controls the sweep parameters.
[SENSe:]SWEep:COUNt
[SENSe:]SWEep:EGATe:HOLDoff
[SENSe:]SWEep:EGATe:POLarity
[SENSe:]SWEep:EGATe:SOURce
[SENSe:]SWEep:EGATe:TYPE
[SENSe:]SWEep:POINts
[SENSe:]SWEep:TIME
[SENSe:]SWEep:COUNt <NumberSweeps>
This command defines the number of sweeps started with single sweep, which are
used for calculating the average or maximum value. If the values 0 or 1 are set, one
sweep is performed.
Parameters:
<NumberSweeps>
Example:
Manual operation:
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
Range: 1 to 100
*RST: 10
Default unit: PCT
FREQ:CENT:STEP:LINK:FACT 20PCT
See "0.1*Span (RF Spectrum)"
See "0.1*Demod BW (AF/RF Time Domain, AF Spectrum)"
on page 41
See "0.5*Span (RF Spectrum)"
See "0.5*Demod BW (AF/RF Time Domain, AF Spectrum)"
on page 41
See "x*Span (RF Spectrum)"
See "x*Demod BW (AF/RF Time Domain, AF Spectrum)"
on page 41
.................................................................................................155
....................................................................................156
....................................................................................156
................................................................................... 156
........................................................................................156
.................................................................................................157
................................................................................................... 157
0 to 32767
*RST: 0 (GSM: 200, PHN:1)
SWE:COUN 64
Sets the number of sweeps to 64.
INIT:CONT OFF
Switches to single sweep mode.
INIT;*WAI
Starts a sweep and waits for its end.
See "Sweep Count" on page 56
on page 40
on page 41
on page 41
155