R&S FSV-K7 Operating Manual page 38

®
R&S FSV-K7/K7S
Squelch Level ← FM
See
PM
Selects PM as the modulation type, changes the signal display, and opens a submenu
to set the measurement configuration.
In single sweep mode, the data is determined from the current I/Q data set, i.e. a
change to a different type does not trigger a new measurement.
This menu is also displayed when you press the [MEAS CONFIG] key after changing
the modulation type.
Remote command:
CALC:FEED 'XTIM:PM' (see
Display Config ← PM
See
Select Trace ← PM
See
Demod BW ← PM
See
Meas Time ← PM
See
AF Filter ← PM
See
AF Range ← PM
See
Time Domain Zoom ← PM
See
Squelch ← PM
See
Squelch Level ← PM
See
Zero Phase Reference Point ← PM
Defines the position at which the phase of the PM-demodulated signal is set to 0 rad.
The entry is made with respect to time. In the default setting, the first measured value
is set to 0 rad.
This softkey is only available in the PM display with DC coupling.
Remote command:
[SENSe:]ADEMod:PM:RPOint[:X]
Operating Manual 1176.7561.02 ─ 06
"Squelch Level" on page 37.
"Display Config" on page 28.
"Select Trace" on page 30.
"Demod BW" on page 30.
"Meas Time" on page 31.
"AF Filter" on page 31.
"AF Range" on page 34.
"Time Domain Zoom" on page 36.
"Squelch" on page 37.
"Squelch Level" on page 37.
Analog Demodulation Option R&S FSV–K7
Softkeys of the Analog Demodulation option
CALCulate<n>:FEED
on page 137
on page 90)
38