R&S FSV-K7 Operating Manual page 185

®
R&S FSV-K7/K7S
Example:
FORMat:DEXPort:DSEParator <Separator>
This command defines which decimal separator (decimal point or comma) is to be
used for outputting measurement data to the file in ASCII format. Different languages
of evaluation programs (e.g. MS-Excel) can thus be supported.
Parameters:
<Separator>
Example:
Manual operation:
DIAGnostic<n>:SERVice:NSOurce <State>
This command switches the 28 V supply of the noise source on the front panel on or
off.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
INITiate<n>:CONMeas
This command restarts a measurement that has been stopped in single sweep mode.
The measurement is restarted at the first sweep point.
As opposed to INITiate<n>[:IMMediate], this command does not reset traces in
maxhold, minhold or average mode. Therefore it can be used to continue measure-
ments using max hold or averaging functions.
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
REAL
REAL data are transmitted as 32-bit IEEE 754 floating-point
numbers in the "definite length block format".
*RST: ASCII
FORM REAL,32
FORM ASC
POINt | COMMA
*RST: (factory setting is POINt; *RST does not affect set-
ting)
FORM:DEXP:DSEP POIN
Sets the decimal point as separator.
See "ASCII Trace Export"
See "Decim Sep" on page 63
See "ASCII File Export"
.
irrelevant
ON | OFF
*RST: OFF
DIAG:SERV:NSO ON
See "Noise Source" on page 76
on page 63
on page 75
185