R&S FSV-K7 Operating Manual page 153

®
R&S FSV-K7/K7S
Parameters:
<FilterType>
Example:
Mode:
Manual operation:
[SENSe:]FILTer<n>:LPASs:FREQuency:RELative <FilterType>
This command selects the relative low pass filter type in the specified window. For
details on filters refer to
For details about the demodulation bandwidth range refer to
Suffix:
<n>
Parameters:
<FilterType>
Example:
Mode:
Manual operation:
2.3.6.7 SENSe:FREQuency Subsystem (Analog Demodulation, R&S FSV–K7)
The SENSe:FREQuency subsystem defines the frequency axis of the active display.
The frequency axis can either be defined via the start/stop frequency or via the center
frequency and span.
[SENSe:]FREQuency:CENTer
[SENSe:]FREQuency:CENTer:STEP
[SENSe:]FREQuency:CENTer:STEP:LINK
[SENSe:]FREQuency:CENTer:STEP:LINK:FACTor
[SENSe:]FREQuency:CENTer <Frequency>
This command defines the center frequency (frequency domain) or measuring fre-
quency (time domain).
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
3kHz | 15kHz | 150kHz
*RST: 15kHz
FILT:LPAS:FREQ 150kHz
Selects the low pass filter for the demodulation bandwidth range
from 400 kHz to 16 MHz.
ADEMOD
See "Low Pass" on page 31
Low Pass softkey.
.
1...4
window
5PCT | 10PCT | 25PCT
*RST: 25PCT
FILT:LPAS:FREQ 25PCT
Selects the low pass filter as 25 % of the demodulation band-
width.
ADEMOD
See "Low Pass" on page 31
......................................................................................... 153
................................................................................154
........................................................................154
"Demod BW"
............................................................155
on page 30.
153