R&S FSV-K7 Operating Manual page 105

®
R&S FSV-K7/K7S
Example:
Manual operation:
CALCulate<n>:MARKer<m>:TRACe <Trace>
This command selects the trace a marker is positioned on.
The corresponding trace must have a trace mode other than "Blank".
If necessary, the corresponding marker is switched on prior to the assignment.
Suffix:
<n>
<m>
Parameters:
<Trace>
Example:
Manual operation:
CALCulate<n>:MARKer<m>:X <Position>
This command positions a marker on a particular coordinate on the x-axis.
If marker 2, 3 or 4 is selected and used as delta marker, it is switched to marker mode.
Suffix:
<n>
<m>
Parameters:
<Position>
Example:
Manual operation:
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
CALC:MARK3 ON
Switches on marker 3 or switches to marker mode.
See "Marker 1 / Marker 2 / Marker 3 / ... Marker 16,/ Marker
Norm/Delta" on page 68
See "Marker Wizard"
.
Selects the measurement window.
depends on mode
Selects the marker.
1 ... 6
Trace number the marker is positioned on.
CALC:MARK3:TRAC 2
Assigns marker 3 to trace 2.
See "Marker to Trace"
See "Marker Wizard"
.
Selects the measurement window.
Selects the marker.
Numeric value that defines the marker position on the x-axis.
The unit is either Hz (frequency domain) or s (time domain) or
dB (statistics).
Range: The range depends on the current x-axis range.
CALC:MARK2:X 1.7MHz
Positions marker 2 to frequency 1.7 MHz.
See "Marker 1 / Marker 2 / Marker 3 / ... Marker 16,/ Marker
Norm/Delta" on page 68
on page 68
on page 68
on page 68
105