[Sense:]Ademod:fm[:Tdomain]:Result - R&S FSV-K7 Operating Manual

®
R&S FSV-K7/K7S
Example:
Mode:
[SENSe:]ADEMod:FM:OFFSet <Type>
This command calculates the FM offset of the currently available measurement data
set.
If averaging has been activated before acquiring the data set (using
]ADEMod:FM[:TDOMain][:TYPE]
eral measurements can also be obtained by setting <result type> = AVERage.
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
ADEM:SET 8MHz,32000,EXT,POS,-500,30, see
on page 138
]ADEMod:SET
Sets demodulator
ADEM:FM AVER,MAXH,MINH, see
on page 129
TDOMain][:TYPE]
Selects the FM results to be measured
ADEM:AM:REL WRIT,OFF,OFF, see
AFSPectrum[:TYPE]
Selects the AM results to be measured
ADEM:FM:AFSP WRIT,OFF,OFF, see
AFSPectrum[:TYPE]
Selects the AF spectrum results of the demodulated FM signal
to be measured
ADEM ON, see
[SENSe:]ADEMod[:STATe]
Switches the demodulator on
INIT; WAI
Starts the measurement and waits for termination
FORM ASC, see
FORMat[:DATA]
Selects output format
ADEM:FM:RES? AVER, see
on page 130
TDOMain]:RESult
Reads FM average result data
ADEM:FM:RES? MAXH, see
on page 130
TDOMain]:RESult
Reads FM maxhold result data
ADEM:FM:RES? MINH, see
on page 130
TDOMain]:RESult
Reads FM minhold result data
ADEM:AM:RES? WRIT, see
ABSolute][:TDOMain]:RESult?
Reads current AM result data
ADEM:FM:AFSP:RES? WRIT
Reads current AF spectrum result data of demodulated FM sig-
nal
ADEMOD
on page 129, the averaged FM offset over sev-
[SENSe:]ADEMod:FM[:
[SENSe:]ADEMod:FM:
on page 131
[SENSe:]ADEMod:FM:
on page 131
on page 121
on page 184
[SENSe:]ADEMod:FM[:
[SENSe:]ADEMod:FM[:
[SENSe:]ADEMod:FM[:
[SENSe:]ADEMod:AM[:
on page 125
[SENSe:
[SENSe:
132