R&S FSV-K7 Operating Manual page 156

®
R&S FSV-K7/K7S
[SENSe:]SWEep:EGATe:HOLDoff <DelayTime>
This command defines the delay time between the external gate signal and the contin-
uation of the sweep.
Note: Using gate mode "level" (see
and an IFP trigger (see
off time for the IFP trigger is ignored for frequency sweep, FFT sweep, zero span and
IQ mode measurements.
Parameters:
<DelayTime>
Example:
[SENSe:]SWEep:EGATe:POLarity <Polarity>
This command determines the polarity of the external gate signal. The setting applies
both to the edge of an edge-triggered signal and the level of a level-triggered signal.
Parameters:
<Polarity>
Example:
Manual operation:
[SENSe:]SWEep:EGATe:SOURce <Source>
This command selects the signal source for gated measurements.
If an IF power signal is used, the gate is opened as soon as a signal at > -20 dBm is
detected within the IF path bandwidth (10 MHz).
For details see the
Parameters:
<Source>
Example:
Manual operation:
[SENSe:]SWEep:EGATe:TYPE <Type>
This command sets the type of triggering by the external gate signal.
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
[SENSe:]SWEep:EGATe:TYPE
TRIGger<n>[:SEQuence]:SOURce
0 s to 30 s
*RST: 0s
SWE:EGAT:HOLD 100us
POSitive | NEGative
*RST: POSitive
SWE:EGAT:POL POS
See "Trigger Polarity"
"Trigger Source" on page 64 softkey.
EXTernal | IFPower | VIDeo | RFPower | PSEN
*RST: IFPower
SWE:EGAT:SOUR IFP
Switches the gate source to IF power.
See "RF Power" on page 64
See "IF Power" on page 65
on page 167), the hold-
on page 66
on page 156)
156