[Sense:]Ademod:am[:Absolute][:Tdomain][:Type] - R&S FSV-K7 Operating Manual

®
R&S FSV-K7/K7S
[SENSe:]ADEMod:AM[:ABSolute][:TDOMain]:RESult? <TraceMode>
This command reads the result data of the RF signal in zero span in the specified trace
mode. The data format of the output data block is defined by the FORMat command
(see
on page 118).
The output unit is dBm (logarithmic display) or V (linear display).
Query parameters:
<TraceMode>
Example:
Usage:
Mode:
[SENSe:]ADEMod:AM[:ABSolute][:TDOMain][:TYPE] <TraceMode>
This command selects the trace modes of the RF signal to be measured simultane-
ously in zero span. For each of the six available traces a mode can be defined.
Parameters:
<TraceMode>
Operating Manual 1176.7561.02 ─ 06
Remote Commands of the Analog Demodulation (R&S FSV–K7)
Chapter 2.3.6.2, "Formats for Returned Values: ASCII Format and Binary
WRITe | AVERage | MAXHold | MINHold | VIEW
The specified trace mode must be one of those configured by

[SENSe:]ADEMod:AM[:ABSolute][:TDOMain][:TYPE]

on page 125. Otherwise a query error is generated.
For details on trace modes see
Result
ADEM:SET 8MHz,32000,EXT,POS,-500,30
Sets up demodulator parameters
ADEM:AM AVER,MAXH,MINH
Sets up AM results to be measured
ADEM ON
Switches on demodulator
INIT; *WAI
Starts measurement and waits for sync
FORM ASC
Selects output format
ADEM:AM:RES? AVER
Reads AM average results
ADEM:AM:RES? MAXH
Reads AM max hold results
ADEM:AM:RES? MINH
Reads AM min hold results
Query only
ADEMOD
<TraceMode1>, <TraceMode2>, <TraceMode3>, <Trace-
Mode4>, <TraceMode5>, <TraceMode6>
WRITe | AVERage | MAXHold | MINHold | VIEW | OFF
For details on trace modes see
Result
*RST:
Analog Demodulation Option R&S FSV–K7
Types", on page 118.
Types", on page 118.
WRITe,OFF,OFF,OFF,OFF,OFF (FM-
Stereo:OFF,OFF,OFF,OFF,OFF,OFF)
Chapter 2.3.6.1, "Trace Mode
Chapter 2.3.6.1, "Trace Mode
Format",
125