R&S FSV-K7 Operating Manual page 219

®
R&S FSV-K7/K7S
The sweep starts after a positive or negative edge of the trigger signal. The default set-
ting is "Pos". The setting applies to all modes with the exception of the "Free Run" and
"Time" mode.
"Pos"
"Neg"
Remote command:
TRIGger<n>[:SEQuence]:SLOPe
[SENSe:]SWEep:EGATe:POLarity
Trigger Offset
Opens an edit dialog box to enter the time offset between the trigger signal and the
start of the sweep.
offset > 0:
offset < 0:
In the "External" or "IF Power" trigger mode, a common input signal is used for both
trigger and gate. Therefore, changes to the gate delay will affect the trigger delay (trig-
ger offset) as well.
In the "Time" trigger mode, this softkey is not available.
Remote command:
TRIGger<n>[:SEQuence]:HOLDoff[:TIME]
Repetition Interval
Opens an edit dialog box to define a repetition interval in which the measurement is
triggered. The shortest interval is 2 ms. This softkey is only available if the trigger
source "Time" is selected (see
Remote command:
TRIGger<n>[:SEQuence]:TIME:RINTerval
Trigger Hysteresis
Defines the value for the trigger hysteresis for "IF power" or "RF Power" trigger sour-
ces. The hysteresis in dB is the value the input signal must stay below the power trig-
ger level in order to allow a trigger to start the measurement. The range of the value is
between 3 dB and 50 dB with a step width of 1 dB.
Operating Manual 1176.7561.02 ─ 06
Instrument Functions FM Stereo (R&S FSV–K7S)
Level triggering: the sweep is stopped by the logic "0" signal and
restarted by the logical "1" signal after the gate delay time has
elapsed.
Edge triggering: the sweep is continued on a "0" to "1" transition for
the gate length duration after the gate delay time has elapsed.
on page 167
on page 156
Start of the sweep is delayed
Sweep starts earlier (pre-trigger)
Only possible for span = 0 (e.g. I/Q Analyzer mode) and gated trigger
switched off
Maximum allowed range limited by the sweep time:
pretrigger = sweep time
max
When using the R&S Digital I/Q Interface (R&S FSV-B17) with I/Q Ana-
lyzer mode, the maximum range is limited by the number of pretrigger
samples.
See the R&S Digital I/Q Interface(R&S FSV-B17) description in the base
unit.
"Time" on page 66).
FM Stereo Option R&S FSV–K7S
on page 163
on page 166
219