R&S FSV-K7 Operating Manual page 50

®
R&S FSV-K7/K7S
●
"Auto Freq"
●
"Auto Level"
Remote command:
[SENSe:]ADJust:ALL
Auto Freq
Defines the center frequency and the reference level automatically by determining the
highest frequency level in the frequency span. This function uses the signal counter;
thus it is intended for use with sinusoidal signals.
This function is not available for input from the R&S Digital I/Q Interface (option
R&S FSV-B17).
Remote command:
[SENSe:]ADJust:FREQuency
Auto Level
Defines the optimal reference level for the current measurement automatically.
The measurement time for automatic leveling can be defined using the
key.
Remote command:
[SENSe:]ADJust:LEVel
Settings
Opens a submenu to define settings for automatic leveling.
Possible settings are:
●
"Meas Time Manual"
●
"Meas Time Auto"
Meas Time Manual ← Settings
Opens an edit dialog box to enter the duration of the level measurement in seconds.
The level measurement is used to determine the optimal reference level automatically
(see the "Auto Level" softkey,
Remote command:
[SENSe:]ADJust:CONFigure:LEVel:DURation
Meas Time Auto ← Settings
The level measurement is used to determine the optimal reference level automatically
(see the
This softkey resets the level measurement duration for automatic leveling to the default
value of 100 ms.
Upper Level Hysteresis ← Settings
Defines an upper threshold the signal must exceed before the reference level is auto-
matically adjusted when the "Auto Level" function is performed.
Remote command:
[SENSe:]ADJust:CONFiguration:HYSTeresis:UPPer
Operating Manual 1176.7561.02 ─ 06
on page 50
on page 50
on page 145
on page 147
on page 50
on page 50
"Auto Level"
Auto Level softkey).
Analog Demodulation Option R&S FSV–K7
Softkeys of the Analog Demodulation option
on page 146
on page 50). The default value is 1 ms.
on page 146
Settings soft-
on page 146
50