Unit (% / Db) - R&S FSV-K7 Operating Manual

®
R&S FSV-K7/K7S
for indication in dB
Intermod.Distortion (On/Off) ← Intermod. Distortion
Enables intermodulation distortion. The results are displayed in the summary table with
the function "IModDist 2/3". The markers are indicated as "IMD2, IMD3".
Remote command:
CALCulate<n>:MARKer:FUNCtion:IMD[:STATe]
Unit (% / DB) ← Intermod. Distortion
Sets the unit to percent or DB for intermodulation distortion.
Remote command:
CALCulate<n>:MARKer:FUNCtion:IMD:UNIT
Search Signals ← Intermod. Distortion
Starts the search of the signals required for the intermodulation distortion measure-
ment.
Remote command:
CALCulate<n>:MARKer:FUNCtion:IMD:SEARchsignal ONCE
n dB down
Opens an edit dialog box to enter a value to define the level spacing of the two tempo-
rary markers to the right and left of marker 1 (default setting: 3 dB). Activates the tem-
porary markers T1 and T2. The values of the temporary markers (T1, T2) and the
entered value (ndB) are displayed in the marker field.
If a positive value is entered, the markers T1 and T2 are placed below the active refer-
ence marker. If a negative value (e.g. for notch filter measurements) is entered, the
markers T1 and T2 are placed above the active reference marker. Marker T1 is placed
to the left and marker T2 to the right of the reference marker.
In the marker table, the following results are displayed:
Span setting
span > 0
span = 0
If it is not possible to form the frequency spacing for the n dB value (e.g. because of
noise display), dashes instead of a measured value are displayed.
Remote command:
CALC:MARK1:FUNC:NDBD:STAT ON, see
NDBDown:STATe
CALC:MARK1:FUNC:NDBD 3dB, see
NDBDown
CALC:MARK1:FUNC:NDBD:RES? , see
NDBDown:RESult?
CALC:MARK:FUNC:NDBD:QFAC?, see
NDBDown:QFACtor
Operating Manual 1176.7561.02 ─ 06
Parameter name
Bw
Q factor
PWid
on page 103
on page 100
on page 102
on page 102
FM Stereo Option R&S FSV–K7S
Instrument Functions FM Stereo (R&S FSV–K7S)
on page 232
on page 232
Description
frequency spacing of the two temporary markers
quality of the displayed bandwidth value (Bw)
pulse width between the two temporary markers
CALCulate<n>:MARKer<m>:FUNCtion:
CALCulate<n>:MARKer<m>:FUNCtion:
CALCulate<n>:MARKer<m>:FUNCtion:
CALCulate<n>:MARKer<m>:FUNCtion:
on page 233
224