R&S FSV-K7 Operating Manual page 163

®
R&S FSV-K7/K7S
TRIGger<n>[:SEQuence]:BBPower:HOLDoff <Value>
This command sets the holding time before the next BB power trigger event (for digital
input via the R&S Digital I/Q Interface, R&S FSV-B17).
Suffix:
<n>
Parameters:
<Value>
Example:
Mode:
Manual operation:
TRIGger<n>[:SEQuence]:HOLDoff[:TIME] <Delay>
This command defines the length of the trigger delay.
A negative delay time (pretrigger) can be set in zero span only.
Suffix:
<n>
Parameters:
<Delay>
Example:
Manual operation:
TRIGger<n>[:SEQuence]:IFPower:HOLDoff <Value>
This command sets the holding time before the next IF power trigger event.
Suffix:
<n>
Parameters:
<Value>
Example:
Manual operation:
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
.
irrelevant
*RST: 150 ns
TRIG:SOUR BBP
Sets the baseband power trigger source.
TRIG:BBP:HOLD 200 ns
Sets the holding time to 200 ns.
all
See "Trigger Holdoff"
.
irrelevant
Range: zero span: -sweeptime (see data sheet) to 30 s;
span: 0 to 30 s
*RST: 0 s
TRIG:HOLD 500us
See "Trigger Offset" on page 66
See "Trigger Offset" on page 219
.
irrelevant
*RST: 150 ns
TRIG:SOUR IFP
Sets the IF power trigger source.
TRIG:IFP:HOLD 200 ns
Sets the holding time to 200 ns.
See "Trigger Holdoff"
on page 67
on page 67
163