R&S FSV-K7 Operating Manual page 39

®
R&S FSV-K7/K7S
Phase Wrap On/Off ← PM
Activates/deactivates the phase wrap.
On
Off
This softkey is available in the PM signal displays.
Remote command:
CALC:FORM PHAS (see
RF Power
Selects RF power as the modulation type, changes the signal display, and opens a
submenu to set the measurement configuration.
In single sweep mode, the data is determined from the current I/Q data set, i.e. a
change to a different type does not trigger a new measurement.
This menu is also displayed when you press the [MEAS CONFIG] key after changing
the modulation type.
Remote command:
CALC:FEED 'XTIM:RFPower' (see
Display Config ← RF Power
See
Select Trace ← RF Power
See
Demod BW ← RF Power
See
Meas Time ← RF Power
See
AF Filter ← RF Power
See
AF Range ← RF Power
See
Time Domain Zoom ← RF Power
See
Squelch ← RF Power
See
Squelch Level ← RF Power
See
Operating Manual 1176.7561.02 ─ 06
The phase will be displayed in the range ±180° (± Π). For example, if the phase exceeds +180°,
360° is subtracted from the phase value, with the display thus showing >-180°.
The phase will not be wrapped.
CALCulate<n>:FORMat
"Display Config" on page 28.
"Select Trace" on page 30.
"Demod BW" on page 30.
"Meas Time" on page 31.
"AF Filter" on page 31.
"AF Range" on page 34.
"Time Domain Zoom" on page 36.
"Squelch" on page 37.
"Squelch Level" on page 37.
Analog Demodulation Option R&S FSV–K7
Softkeys of the Analog Demodulation option
on page 93)
CALCulate<n>:FEED
on page 90)
39