R&S FSV-K7 Operating Manual page 111

®
R&S FSV-K7/K7S
Suffix:
<n>
<t>
Parameters:
<Mode>
Example:
Manual operation:
DISPlay[:WINDow<n>]:TRACe<t>[:STATe] <State>
This command switches on or off the display of the corresponding trace. The other
measurements are not aborted but continue running in the background.
Suffix:
<n>
<t>
Parameters:
<State>
Example:
Manual operation:
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe] <Range>
This command defines the display range of the y-axis with logarithmic scaling.
The command works only for a logarithmic scaling. You can select the scaling with
DISPlay[:WINDow<n>]:TRACe<t>:Y:SPACing
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
.
window; For applications that do not have more than 1 measure-
ment window, the suffix <n> is irrelevant.
trace
WRITe | VIEW | AVERage | MAXHold | MINHold | BLANk
*RST: WRITe for TRACe1, STATe OFF for
TRACe2/3/4/5/6
For details on trace modes refer to
Overview", on page 17.
INIT:CONT OFF
Switching to single sweep mode.
SWE:COUN 16
Sets the number of measurements to 16.
DISP:TRAC3:MODE MAXH
Switches on the calculation of the maximum peak for trace 3.
INIT;*WAI
Starts the measurement and waits for the end of the 16 sweeps.
See "Clear Write" on page 17
See "Max Hold" on page 18
See "Min Hold" on page 18
See "Average" on page 18
See "View" on page 18
.
window; For applications that do not have more than 1 measure-
ment window, the suffix <n> is irrelevant.
trace
ON | OFF
*RST: ON for TRACe1, OFF for TRACe2 to 6
DISP:TRAC3 ON
See "Blank" on page 19
Chapter 2.1.7, "Trace Mode
on page 114.
111