R&S FSV-K7 Operating Manual page 83

®
R&S FSV-K7/K7S
GSM
IQ
OFDM
OFDMA/WiBro
NF
PHN
PSM
SFM
SPECM
TDS
VSA
WCDMA
WLAN
The spectrum analysis mode is implemented in the basic unit. For the other modes, the
corresponding options are required.
Upper/Lower Case Notation
Upper/lower case letters are used to mark the long or short form of the key words of a
command in the description. The instrument itself does not distinguish between upper
and lower case letters.
Special Characters
|
Example:
SENSe:FREQuency:CW|:FIXed
The two following commands with identical meaning can be created. They set the fre-
quency of the fixed frequency signal to 1 kHz:
SENSe:FREQuency:CW 1E3
SENSe:FREQuency:FIXed 1E3
A vertical stroke in parameter indications marks alternative possibilities in the sense of
"or". The effect of the command differs, depending on which parameter is used.
Example: Selection of the parameters for the command
Operating Manual 1176.7561.02 ─ 06
Remote Commands of the Analog Demodulation (R&S FSV–K7)
GSM/Edge measurements (option R&S FSV-K10)
IQ Analyzer mode
WiMAX IEEE 802.16 OFDM measurements (option R&S FSV-K93)
WiMAX IEEE 802.16e OFDMA/WiBro measurements (option R&S FSV-K93)
Noise Figure measurements (R&S FSV-K30)
Phase Noise measurements (R&S FSV-K40)
Power Sensor measurements (option R&S FSV-K9)
Stereo FM measurements (optionR&S FSV-K7S)
Spectogram mode (option R&S FSV-K14)
TD-SCDMA base station / UE measurements (option R&S FSV-K76/K77)
Vector Signal Analysis (option R&S FSV-K70)
3GPP Base Station measurements (option R&S FSV-K72), 3GPP UE measure-
ments (option R&S FSV-K73)
WLAN TX measurements (option R&S FSV-K91)
A selection of key words with an identical effect exists for several commands. These keywords
are indicated in the same line; they are separated by a vertical stroke. Only one of these key-
words needs to be included in the header of the command. The effect of the command is inde-
pendent of which of the keywords is used.
Analog Demodulation Option R&S FSV–K7
83