R&S FSV-K7 Operating Manual page 184

®
R&S FSV-K7/K7S
Parameters:
<State>
Example:
Mode:
OUTPut:IF[:SOURce] <Source>
This command selects the source of the IF output.
Parameters:
<Source>
Example:
Manual operation:
OUTPut:TRIGger <PortLevel>
This command selects level of the Trigger Out port. Thus, you can trigger an additional
device via the external trigger port, for example.
Parameters:
<PortLevel>
Example:
Manual operation:
2.3.10.5 Other Commands
FORMat[:DATA] <Format>
This command selects the data format for the data transmitted from the
R&S FSVA/FSV to the controlling computer. It is used for the transmission of trace
data. The data format of trace data received by the instrument is automatically recog-
nized, regardless of the format which is programmed.
(See also
Parameters:
<Format>
Operating Manual 1176.7561.02 ─ 06
Remote Commands of the Analog Demodulation (R&S FSV–K7)
ON | OFF
*RST:
OUTP:DIQ ON
ADEMOD, IQ, VSA
IF
Outputs the intermediate frequency.
VIDeo
Outputs the video signal (200 mV).
*RST:
OUTP:IF VID
Selects the video signal for the IF output connector.
See "Video Output"
LOW | HIGH
*RST:
OUTP:TRIG HIGH
See "Trigger Out"
TRACe<n>[:DATA]?
ASCii
ASCII data are transmitted in plain text, separated by commas.
Analog Demodulation Option R&S FSV–K7
OFF
IF
on page 76
LOW
on page 77
on page 160).
184