R&S FSV-K7 Operating Manual page 143

®
R&S FSV-K7/K7S
Parameters:
<Threshold>
Example:
Usage:
Mode:
Manual operation:
[SENSe:]ADEMod:SRATe?
This command returns the sample rate set up for the current analog demodulation
measurement.
Example:
Usage:
Mode:
[SENSe:]ADEMod<n>:ZOOM[:STATe] <State>
The command enables or disables the zoom function for the analog-demodulated mea-
surement data in the specified window. Depending on the selected measurement time
and the demodulation bandwidth, the number of recorded test points may be greater
than that shown on the display.
If the zoom function is enabled, the default number of sweep points in "Spectrum"
mode of the result memory are displayed from the specified start time with
]ADEMod<n>:ZOOM:STARt
If the zoom function is disabled, data reduction is used to adapt the test points to the
number of points available on the display.
Suffix:
<n>
Parameters:
<State>
Example:
Mode:
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
numeric value
The absolute threshold level
Range: -150 dBm to 30 dBm
*RST: -40 dBm
DEM:SQU:LEV -80
If the signal drops below -80 dBm, the demodulated data is set
to 0.
SCPI confirmed
ADEMOD, SFM
See "Squelch Level" on page 37
ADEM:SRAT?
Returns the current sample rate.
Query only
ADEMOD
on page 144.
.
1...4
window
ON | OFF
*RST: OFF
ADEM:ZOOM ON
Switches on the zoom function
ADEMOD
[SENSe:
143