R&S FSV-K7 Operating Manual page 142

®
R&S FSV-K7/K7S
[SENSe:]ADEMod:SPECtrum:SPAN:ZOOM <FreqRange>
This command sets the frequency range for the RF spectrum result display determined
from analog demodulation data. The frequency range for result display is limited to the
maximum span (
to the measurement bandwidth of analog demodulation (
BANDwidth|BWIDth:DEModulation
Parameters:
<FreqRange>
Example:
Mode:
Manual operation:
[SENSe:]ADEMod:SQUelch[:STATe] <State>
This command activates the squelch function, i.e. if the signal falls below a defined
threshold (see
data is automatically set to 0.
Parameters:
<State>
Example:
Usage:
Mode:
Manual operation:
[SENSe:]ADEMod:SQUelch:LEVel <Threshold>
This command defines the level threshold below which the demodulated data is set to
0 if squelching is enabled (see
Operating Manual 1176.7561.02 ─ 06
Remote Commands of the Analog Demodulation (R&S FSV–K7)
[SENSe:]ADEMod:SPECtrum:SPAN[:MAXimum]
*RST: 5 MHz
ADEM ON, see
Switches on the analog demodulator
CALC:FEED 'XTIM:SPEC', see
on page 90
Switches on RF spectrum result display.
ADEM:SPEC:SPAN:MAX 5 MHz, see
SPECtrum:SPAN[:MAXimum]
Sets the maximum span to 5 MHz
ADEM:SPEC:SPAN:ZOOM 1 MHz
Sets displayed span to 1 MHz
ADEMOD
See "Span Manual (RF Spectrum)"
See "Full Span (RF Spectrum)"
[SENSe:]ADEMod:SQUelch:LEVel
ON | OFF
*RST: OFF
DEM:SQU ON
Signals below the level threshold are squelched.
SCPI confirmed
A, ADEMOD, SFM
See "Squelch"
[SENSe:]ADEMod:SQUelch[:STATe]
Analog Demodulation Option R&S FSV–K7
[SENSe:]ADEMod:
on page 129).
[SENSe:]ADEMod[:STATe]
CALCulate<n>:FEED
on page 141
on page 42
on page 43
on page 142), the demodulated
on page 37
on page 141) or
on page 121
[SENSe:]ADEMod:
on page 142).
142