R&S FSV-K7 Operating Manual page 180

®
R&S FSV-K7/K7S
Parameters:
<Level>
Example:
Mode:
Manual operation:
INPut:DIQ:RANGe[:UPPer]:UNIT <Unit>
Defines the unit of the full scale level (see
units depends on the measurement application you are using.
This command is only available if the optional R&S Digital I/Q Interface (option
R&S FSV-B17) is installed.
For details see the R&S Digital I/Q Interface (R&S FSV-B17) description of the base
unit.
Parameters:
<Level>
Example:
Mode:
Manual operation:
INPut:DIQ:SRATe <SampleRate>
This command specifies or queries the sample rate of the input signal from the R&S
Digital I/Q Interface (see
Note: the final user sample rate of the R&S FSVA/FSV may differ and is defined using
SENSe:ADEM:SRATe (see
This command is only available if the optional R&S Digital I/Q Interface (option
R&S FSV-B17) is installed.
For details see the R&S Digital I/Q Interface (R&S FSV-B17) description of the base
unit.
Parameters:
<SampleRate>
Example:
Mode:
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
<numeric value>
Range: 70.711 nV to 7.071 V
*RST: 1 V
INP:DIQ:RANG 1V
A, IQ, NF, TDS, VSA, CDMA, EVDO, WCDMA, ADEMOD, GSM,
OFDM, OFDMA/WiBro, WLAN
See "Full Scale Level"
"Level Unit"
V | dBm | dBpW | W | dBmV | dBuV | dBuA | A
*RST: Volt
INP:DIQ:RANG:UNIT A
IQ, VSA, EVDO, CDMA, WCDMA, GSM, ADEMOD, TDS
See "Level Unit" on page 78
"Input Sample Rate"
[SENSe:]ADEMod:SRATe?
Range: 1 Hz to 10 GHz
*RST: 32 MHz
INP:DIQ:SRAT 200 MHz
A, IQ, NF, TDS, VSA, CDMA, EVDO, WCDMA, ADEMOD, GSM,
OFDM, OFDMA/WiBro, WLAN
on page 78
on page 78). The availability of
on page 78).
on page 143).
180