R&S FSV-K7 Operating Manual page 244

®
R&S FSV-K7/K7S
[SENSe:]SFM:<ChannelType>:RSUMmary:REFerence[:AUTO] ONCE
This command determines the reference deviation from the current channel measure-
ment.
Suffix:
<ChannelType>
Example:
Mode:
Manual operation:
[SENSe:]SFM:<ChannelType>:TDOmain:RESult? <TraceMode>
This command reads the result data of the FM stereo signal in zero span in the speci-
fied trace mode. The data format of the output data block is defined by the FORMat
command (see
Binary
The output units are described in
on page 104.
Suffix:
<ChannelType>
Query parameters:
<TraceMode>
Example:
Usage:
Mode:
[SENSe:]SFM:<ChannelType>:TDOmain:TYPE <TraceMode>
This command selects the trace modes of the FM stereo signal to be measured simul-
taneously in zero span. For each trace a mode can be defined, however only if the
specified channel is currently displayed in one of the four screens. If a trace mode is
set for a channel that is not displayed, a query error is generated.
Suffix:
<ChannelType>
Operating Manual 1176.7561.02 ─ 06
Remote Commands of the FM Stereo Option (R&S FSV–K7S)
.
LEFT | RIGHt | MPX | MONO | STEReo | RDS | PILot
Channel type for which the command is performed.
SFM:LEFT:RSUM:REF ONCE
SFM
See "Result Summary Setup"
See "Meas To Ref"
Chapter 2.3.6.2, "Formats for Returned Values: ASCII Format and
Format", on page 118).
.
LEFT | RIGHt | MPX | MONO | STEReo | RDS | PILot
Channel type for which the command is performed.
WRITe
At least one screen must display a left channel that has the trace
mode "Write" specified using
ABSolute][:TDOMain][:TYPE]
query error is generated.
SFM:LEFT:TDOM:RES WRIT
Returns the current trace results in the left channel.
Query only
SFM
.
LEFT | RIGHt | MPX | MONO | STEReo | RDS | PILot
Channel type for which the command is performed.
FM Stereo Option R&S FSV–K7S
on page 196
on page 197
CALCulate<n>:MARKer<m>:PEXCursion
[SENSe:]ADEMod:AM[:
on page 125. Otherwise a
244