R&S FSV-K7 Operating Manual page 242

®
R&S FSV-K7/K7S
Parameters:
<FilterType>
Example:
Mode:
[SENSe:]SFM:<ChannelType>:RSUMmary:COUPling <State>
This command couples the channel settings to other channels, i.e. channels for which
this command is set to "ON" are configured identically.
Suffix:
<ChannelType>
Parameters:
<State>
Example:
Mode:
Manual operation:
[SENSe:]SFM:<ChannelType>:RSUMmary:DETector[:FUNCtion] <Detector>
This command defines the detector used to determine the deviation value of the left
channel of the FM stereo signal in the result summary.
Suffix:
<ChannelType>
Parameters:
<Detector>
Operating Manual 1176.7561.02 ─ 06
Remote Commands of the FM Stereo Option (R&S FSV–K7S)
5PCT | 10PCT | 25PCT
*RST: 25PCT
SFM:LEFT:FILT:LPAS:FREQ 25PCT
Selects the low pass filter as 25 % of the demodulation band-
width.
SFM
.
LEFT | RIGHt | MPX | MONO | STEReo | RDS | PILot
Channel type for which the command is performed.
ON | OFF
*RST: OFF
SFM:LEFT:RSUM:COUP ON
SFM
See "Result Summary Setup"
See "Coupled" on page 197
.
LEFT | RIGHt | MPX | MONO | STEReo | RDS | PILot
Channel type for which the command is performed.
RMS | SRMS | PPEak | NPEak | PAVerage | QPEak | SQPeak
RMS
RMS
SRMS
RMS*SQRT2
PPEak
Positive peak
NPEak
Negative peak
PAVerage
±Peak/2
FM Stereo Option R&S FSV–K7S
on page 196
242